46
National patents
Ce Certified Commercial Concrete Floor Coatings Factory
The CE marking indicates that the coating system meets the essential health, safety, and environmental requirements of the European Construction Products Regulation. For concrete floor coatings, this
Order this product
CE Certified Commercial Concrete Floor Coatings Factory
The CE marking indicates that the coating system meets the essential health, safety, and environmental requirements of the European Construction Products Regulation. For concrete floor coatings, this includes limits on volatile organic compounds, fire performance, and mechanical durability under prescribed test methods.
Typical compressive strength after 28 days curing exceeds 45 MPa, providing resistance to heavy wheel loads and impact. Abrasion resistance measured by Taber abrasion test shows less than 80 mg loss per 1000 cycles for a 2 mm thick film. The coating maintains slip resistance (R10 or higher) when a fine aggregate is incorporated into the top layer.
| Property | Test Method | Typical Value | Unit |
|---|---|---|---|
| Compressive strength | EN 196‑1 | ≥45 | MPa |
| Abrasion resistance (Taber) | EN 13892‑4 | ≤80 | mg/1000 cycles |
| Slip resistance (wet) | EN 13036‑4 | R10–R12 | — |
| VOC content | EU Directive 2004/42/EC | ≤50 | g/L |
| Cure to foot traffic | ASTM D1640 | 4–6 | h |
In logistics centers, the coating distributes point loads from pallet trucks across the slab, reducing cracking and dust generation. In food‑processing facilities, the low VOC formulation and seamless surface simplify cleaning regimes and help meet hygiene standards. For parking decks, the UV‑stable pigment package limits yellowing while the abrasion layer withstands tire studs and de‑icing chemicals. Each application relies on the coating’s ability to bond to prepared concrete, forming a monolithic layer that transfers shear stresses without delamination.
Raw material batches are checked for viscosity and solids content before mixing, ensuring consistent film thickness across production runs. After application, wet film thickness is monitored with laser gauges, and cured samples are pulled for pull‑off adhesion testing according to EN 1542. Final inspection includes gloss measurement and color difference (ΔE) verification against the approved standard.
Customization Options
- Pigment selection: standard grey, safety yellow, or custom RAL colors.
- Aggregate size: fine silica for slip resistance or coarse quartz for enhanced wear.
- Thickness range: 1.5 mm to 3.0 mm adjustable via spray passes.
- Add‑ons: antimicrobial agents, anti‑static conductive fillers, or UV absorbers.
Frequently Asked Questions
Can the coating thickness be adjusted for specific load requirements?
Yes, the spray equipment allows variation from 1.5 mm to 3.0 mm in 0.25 mm increments, enabling designers to match the coating to expected traffic loads.
What documentation is provided to confirm CE compliance?
Each batch is accompanied by a Declaration of Performance, test reports according to EN 13813, and the CE marking label affixed to the packaging.
How are color variations controlled across large projects?
Color is measured with a spectrophotometer; tolerances are kept within ΔE < 1.5 between batches, and a master batch is retained for reference.
#
01
Vinyl flooring line
600
K+ SQ.M capacity
2007
Founded